Product Listing Electronics

Dual battery voltage regulator

Large heat sink for optimum performance

- Dual HD AWG22 input/ouput connectors to double current capacity and redundancy,
-Output is factory preset to 5.95V
-fully adjustable between 5V to 6.5V,
-When input is higher than 6V or any set voltage, it will regulate to 6V or any set voltage.
-When input drop below set voltage, regulator is bypassed,
-Input Range: 4.8V -12V
-Note: Current capacity drops as input voltage increases

$24.95

View Cart

Check Out

Heavy duty adjustable voltage regulator

Adjustable output voltage,

-Large heat sink for optimum performance,
- Weight only 1.4 oz,
-Current: 15 Amp continuous, 30 Amp peak @7.4V input and 6V output,
- Max input voltage: 16V,
- Output voltage range: 4.8-8V.
-Input voltage must be at least 1V higher than output.
-Note: Current capacity drops as input voltage increases

$33.00

View Cart

Check Out

Opto Gas Kill Switch

This device allows you to safely and remotely kill your electronic ignition equipped engine from your transmitter. Ignition system is Fiber Optically Coupled to isolate your igniton system from your radio system .(No Interference!!)

This device features the following:

1. Includes a remote mountable bright LED to indicate when the ignition is armed.
2. Fiber Optic input/output.
3. PIC12F675 Controller
4. Li-Po/Li-lon/A123/Ni-Mh/NiCad Input.
5. Up to 20 Volt 16 amp MOS-FET {IRF7456} output.
6. Low to 3Volt 3amp output.
7. Low Voltage Drop-Less than 150mv.
8. 100% Surface Mount Technology.
9. Heavy Gauge Wires,universal connectors.
10. Small and light weight –only 0.3 OZ!(8g)
11. Reverse Battery input protection.
12. Shut down the transmitter power or receiver to cut off automatically

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane!

This device allows you to safely kill your engine at anytime (on the ground ,or in the air!

$19.99

View Cart

Check Out